ABOUT US / About Aniwell


Regenerative Thermal Oxidizers (RTOs)
Aniwell Corporation can supply a range of RTOs to match your process requirements. from two bed, to the three bed design, up to multiple beds. Standard to our regenerative thermal oxidizers are the following features:

  • Ceramic interior insulation rated for operating temperatures up to 2300°F mounted to a plate steel exterior skin
  • Fully welded exterior skin with no possibility of leakage
  • Elimination of hot spots on the exterior skin by the use of superior construction techniques
  • Structured ceramic heat exchange media that minimizes pressure drop,eliminates compacting and lowers the utility cost of operating the oxidizer fan
  • Single burner design with one combustion chamber minimizing maintenance
  • Fully piped and wired gas trains
  • Complete control panels and electrical components.
  • Variable speed control of the oxidizer fan for multiple process lines
  • Destruction efficiency greater than 95 ~99%

 We can include a wide range of options with our thermal oxidizers including:

  • Heat exchanger efficiencies to 98%
  • Hot side heat exchanger bypass
  • Installation
  • Waste heat recovery

Recuperative Oxidizers 
Aniwell Corporation has manufactured recuperative thermal oxidizers since its inception. We use only construction techniques that are proven by years of equipment operation. You will not find a thermal oxidizer built by us that uses a plate type heat exchanger.They fail prematurely compared to tube and shell heat exchangers. 

  • Standard to our recuperative thermal oxidizers are the following features:
  • Stainless steel tube and shell heat exchangers
  • Ceramic block or hardboard interior insulation mounted to a plate steel exterior skin
  • Fully welded exterior skin with no possibility of leakage
  • Elimination of hot spots on the exterior skin by the use of superior construction techniques
  • Fully piped and wired gas trains
  • Complete control panels and electrical components.

We can include a wide range of options with our thermal oxidizers including:

  • Multi-pass primary heat exchangers for higher heat exchanger efficiency
  • Multi-pass secondary heat exchangers where indirect feedback of heat to the process is desired
  • Direct feedback systems where direct feedback of heated air to the process is desired
  • Hot and cold side heat exchanger bypasses
  • Self cleaning tube bundles where silicone release coatings create a high load of dust